Sikaflex® 15LM Aluminum Grey, 300ML Cartridge

2_0703190
$0.00 / EACH
Sikaflex® 15LM is a low modulus, high performance, one-component, polyurethane-based, non-sag elastomeric sealant. Typical applications include joints in panel and wall systems, around window and door frames, reglets, flashings, etc.
QTY
  • PRODUCT HIGHLIGHTS
  • APPLICATIONS
  • HOW TO APPLY
• Capable of +100% / -50% joint movement • Easy and ready to gun • Eliminates time, effort, waste, and equipment cleaning • Cures to a durable, flexible consistency • Excellent cut and tear resistance • Stress relaxation properties • Non leaching • UL certified to CAN/ULC-S115-05: Standard Method of Firestop Systems and to ANSI/UL 2070: Fire Resistance of Building Joint Systems (FF-S-0037, FW-S-0018, HW-S-0095, WW-S-0060) for use in Canada. Specific joint designs and substrates apply in Canada (see Limitations) • Low modulus of elasticity • Excellent adhesion • Bonds to most construction materials, often without primer • Excellent resistance to aging, weathering • Proven in tough climates around the world • Can be painted with water-, oil- and rubber-based paints • Meets CAN/CGSB 19.13-M87, Classification MCG-2-40-B-N • Meets Federal Specification TT-S-00230C, Type II, Class A • Meets Federal Specification TT-S-00227E • SWRI validated • USDA acceptance • Meets ASTM C719 Ext.+100% Comp.-50% • Meets ASTM C1382 when used in Exterior Insulation Finish Systems (EIFS) Joints • Meets ASTM C920, Type S, Grade NS, Class 100/50. Use T, NT, G, A, O, M • Meets Federal Specification for Silicones TT-S-001543A, Type NON SAG • Ministère des Transports du Québec acceptance
Recommended application temperatures between 4 to 38°C (39 to 100°F). For cold-weather application, store units at approximately 21°C (70°F); remove just prior to using. Make sure joint is frost-free. Cut plastic tip on cartridge to desired joint size. Puncture airtight seal at base of tip. Place nozzle of gun into bottom of joint and fill entire joint. Keeping the nozzle deep in the sealant, continue with a steady flow of sealant preceding nozzle to avoid air entrapment.Also, avoid overlapping of sealant since this also entraps air. Tool as required. Proper joint design for moving joints is 2:1 width to depth ratio, with a recommended 6 mm (1/4 in) minimum and 13 mm (1/2 in) maximum depth of sealant. For non-moving joints, the width to depth ratio can vary. Install with hand or power operated caulking gun. For best performance, Sikaflex® 15LM should be gunned into joint when joint slot is at mid-point of its designed expansion and contraction.
All joint surfaces must be clean, sound, dry and frost-free. Joint walls must be free of oils, tar, asphalt, bitumen, grease, paints, coatings, sealers, curing compound residues and any other foreign matter that might prevent adhesion. Ideally this should be accomplished by mechanical means. Bond breaker tape or backer rod must be used in bottom of joint to prevent bond