Perma Chink Cedar Wash Log Cleaner, 18.93 L

$0.00 / EACH
Perma-Chink Cedar Wash is a ready-to-use cleaner specifically formulated for preparing the bare wood surfaces of wood species that contain high levels of wood extractives and resin oils. Cedar Wash is designed to remove surface resin oils and high concentrations of water-soluble wood extractives in addition to dirt, grease, grime, pollen, and surface mold and mildew without harming the wood.
  • Cedar Wash should be used on bare wood surfaces for prep only
  • Very Low environmental impact
  • It removes resin oils and wood extractives, dirt, dust and pollen
  • Will not harm existing wood finishes, chinking and sealants
E-Wood is a two component epoxy putty that can be used to fill holes or voids in wood. E-Wood should not be used to fill checks or gaps between logs since once it cures it has no flexibility and any movement will cause it to pull away from the wood. E-Wood is somewhat challenging to mix together since both components are thick and putty-like. Equal amounts of both A and B components must be kneaded together by hand until the color is uniform throughout the mass. Up to two (2) ounces of LIFELINE™ stains can be added to 24 ounces (12 ounces of component A and 12 ounces of component B) of blended E-Wood to aid in the hiding of the repair. Once it is thoroughly mixed, it can then be pressed into the void and shaped to match the contour of the surface. Application temperature is from 40° F to 90° F and may be applied by hand, putty knife or trowel. If desired a texture or pattern may be worked into the surface of the uncured E-Wood to help it blend in with the surrounding wood. Stain can be applied to the surface of the E-Wood either before or after it has cured. E-Wood will begin to harden in about an hour or two. Being an epoxy, no shrinkage will occur once the E-Wood is in place.