Perma-Chink Energy Seal 507 White, 18.93 L

2_33600842
$0.00 / EACH
Perma-Chink Energy Seal was created specifically to seal milled or scribed log homes, log siding homes, and around joinery such as butt-joints, trim, and corners. One application makes any log wall completely weather-tight. Energy Seal has excellent adhesion and stretch. It is long-lasting, UV-stable, and chemical-resistant. Energy Seal is textured to match the visual characteristics of wood. It easily tools to a smooth, professional finish, virtually disappearing into the walls after it's applied. It softens the lines on log walls and accepts the color of wood finishes.
QTY
  • PRODUCT HIGHLIGHTS
  • HOW TO APPLY
  • Highly Elastic
  • Eliminates Air and Water Infiltration
  • Very low VOC Formula
  • For Exterior and Interior
  • Soap Water Cleanup
  • Lightly textured appearance
  • Remains Flexible to Allow for Log Movement
ENERGYSEAL is compatible with most stains. For maximum adhesion and least visibility use ENERGYSEAL on bare wood prior to staining. If ENERGYSEAL is to be used over newly applied stains or topcoats, apply the product in an obscure area, wait 24 hours and test for adhesion. Do not apply ENERGYSEAL in direct sunlight or when the temperature is less than 40° F. All surfaces should be clean and free of contaminates including dirt, dust, mold, mildew, oil and wax. Use appropriate materials to clean and prepare surfaces. Do not apply ENERGYSEAL over old caulk. If a wood preservative has been previously applied, make sure it is completely dry before applying. ENERGYSEAL may be applied with a bulk loading caulk gun or applicator bag. Hold the applicator tip firmly against the back surface and apply. Apply enough sealant to maintain a wet thickness of 3/8” across the entire joint after tooling. Only apply as much sealant as you can tool in about 15 minutes. Once the joint is filled, spray with a light mist of water and tool smooth with a trowel or spatula. If the width of the trowel is close to the width of the joint, the smoothing process will be easier. Make sure there is good contact between the ENERGYSEALand the exposed edges of the top and bottom logs. If you are a first time applicator, start work on a less visible area until you become familiar with the process. Protect freshly applied ENERGYSEALfrom direct rainfall for a minimum of 24 hours. Drying time and curing time are two entirely different terms. In warm or hot weather, ENERGYSEAL will begin to skin over in as little as ten minutes while a complete cure may take three to four weeks. Cooler weather will slow both the drying time and curing process.