Perma-Chink Strip It Stain & Finish Remover, 18.9 L

2_33601040
$0.00 / PAIL
Perma-Chink StripIt is a water based, non-hazardous, pH neutral stain and finish remover. StripIt does not darken the wood. StripIt removes multiple layers in one application. StripIt is odor free and can be used for interior and exterior applications. It will not raise the grain of the wood. Strip It contains no harsh chemicals, is biodegradable and non-flammable, and unlike caustic strippers, StripIt will not darken nor discolor the wood. Learn more about Perma-Chink.
QTY
  • PRODUCT HIGHLIGHTS
  • HOW TO APPLY
  • Zero V.O.C
  • fast acting remover
  • Environmentally friendly
  • Removes all stain and finishes
Cover/protect/mask areas with plastic sheeting where removal is not required. Cover plants and vegetation. Please read lead paint warning on this label before removing any paint. Workers must wear impervious gloves, apron, footwear and safety goggles while using StripIt®. Take wind drift into consideration if spraying. 2. StripIt® is a ready to use product. Do not dilute. 3. Apply using brush, roller or airless sprayer, at a thickness of 30-35 mils. Two passes will be necessary to achieve required thickness when applying with an airless sprayer. All filters must be removed when applying with an airless sprayer. The recommended tip size for airless sprayer applications is #521. When applying with an airless sprayer, begin application at the bottom and work up. Do not apply thin. Applying thin may result in an additional product application. Air and surface temperatures should be between 55F - 90F for best results. Lower temperatures may require increased dwell time. Higher temperatures and hot surfaces might dry out the remover. If necessary, cover remover with StripIt Paper or plastic to prevent drying when working in direct sunlight and air temperature is 90F or higher. 4. Removal requires a minimum of several hours for low solids stains and finishes, to 24 hours for high solids, multiple layer removals. Some removals might require several days of dwell time. Do not allow StripIt® to dry. If product begins to dry, re-apply StripIt® and cover with StripIt® Paper or plastic. 5. Once stain/finish has softened and lifted, remove using a scraper, putty knife or pressure washer. If using a pressure washer to remove stain/finish/remover residue, start at the bottom and work up. You do not want to wash away the Remover from areas that are not ready for removal. Hold the pressure washer wand at a 30-45 degree angle from the wall. The objective is to “peel” the softened finish from the surface, and not to blast it off with a lot of water pressure. This will help avoid gouging the surface and severe feathering. If there are some remaining spots of finish, try scraping these areas with a paint scraper or a stiff nylon brush before they dry. 6. Thoroughly rinse surface to remove any remaining residue. Collect all remover waste and stain/finish residue for proper disposal in accordance with all government regulations. 7. Allow surface to thoroughly dry before applying stain.